RC-Monster Forums - View Single Post - BL buggy mock-up etc.

joeling · 11.16.2005, 07:52 PM

hi Serum,

Thanks for your comments. I had a local machinist fabricate this for me based on my crude drawings.

The bearing used is the type used in nitro engines. I figured that with the extension shaft, I need the extra support at the other end. This was done out of neccessity.

I am using 15T pinion & 46T spur. I think this is too tall a gearing. I cannot seem to locate my 14T pinion. So I am trying to get some from Mike. I think I will switch to 13T while I wait for the 14T. What do you think ?

Regards,
Joe Ling

	(#24)
joeling RC-Monster Carbon Fiber Offline Posts: 463 Join Date: Aug 2005 Location: Malaysia	11.16.2005, 07:52 PM hi Serum, Thanks for your comments. I had a local machinist fabricate this for me based on my crude drawings. The bearing used is the type used in nitro engines. I figured that with the extension shaft, I need the extra support at the other end. This was done out of neccessity. I am using 15T pinion & 46T spur. I think this is too tall a gearing. I cannot seem to locate my 14T pinion. So I am trying to get some from Mike. I think I will switch to 13T while I wait for the 14T. What do you think ? Regards, Joe Ling Hyper 9e Medusa 4S, Savage 5S MMM 8XL, Jammin' 4S Neu MMM, X2 Ninja JX, X2 MMM 5S Neu, E REVO Medusa 6S