BL buggy mock-up etc.

[joeling]

hi Serum,

Thanks for your comments. I had a local machinist fabricate this for me based on my crude drawings.

The bearing used is the type used in nitro engines. I figured that with the extension shaft, I need the extra support at the other end. This was done out of neccessity.

I am using 15T pinion & 46T spur. I think this is too tall a gearing. I cannot seem to locate my 14T pinion. So I am trying to get some from Mike. I think I will switch to 13T while I wait for the 14T. What do you think ?

Regards,
Joe Ling