Thread: Is there a way to get rid of the on/off switch on the mm esc and have it still work?
View Single Post
Old
  (#8)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
11.30.2008, 11:08 AM
Quote:
Originally Posted by lincpimp View Post
You have to solder the two pads together or use a small loop of wire to connect them. Or the mm will not be on.
Right now there is a small dab of soldier on the board where the 2 wires are supposed to be soldiered to, nothing more. So you are saying that if I connect the contact points at the board w/soldier it will work? Or would a small loop of wire connecting them be better.

1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
   
Reply With Quote