|
12.18.2008, 05:40 PM
I wish it were that simple. Remember that the output shaft goes through that hole, and if you remove too much plastic you can enlarge the opening the output shaft goes through. This isn't good because then the diff won't be supported well enough by the output shafts.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|