RC-Monster Forums - View Single Post - Soldering/Wiring/Ice ESC/Bullets PROBLEMS & QUERIES

_paralyzed_ · 04.19.2011, 09:25 AM

The BEC does not connect directly to the servos, you simply plug the BEC into channel 3 on the receiver and the servos pull power from the power rail in the receiver.

Dremel the tinned ends until they fit. You only have to remove solder, once down to the wires it will fit. I just did this with my Mamba XL, with no problems whatsoever. Don't worry about bottle necking.

	(#4)
_paralyzed_ working on a brushless for my wheelchair..... Offline Posts: 4,890 Join Date: Mar 2007 Location: minnesnowta	04.19.2011, 09:25 AM The BEC does not connect directly to the servos, you simply plug the BEC into channel 3 on the receiver and the servos pull power from the power rail in the receiver. Dremel the tinned ends until they fit. You only have to remove solder, once down to the wires it will fit. I just did this with my Mamba XL, with no problems whatsoever. Don't worry about bottle necking. _______________________________________ It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper.