RC-Monster Forums - View Single Post

Kcaz25 · 10:53 AM

I sortof hate to fully reveal what I'm working on before I'm finished but I need help. Now, no wiring has been done. I have to shorten(inches!) and route the wires all of them and mount the RX. Also some of the screws are mocked up and are loose. So what do you think about this?

Obviously I am wanting to go under the rear drive shaft. It has enough clearance surprisingly. The wires pretty much have to come out of the ESC at a 90 then go down at like another 90 then go straight to the motor along the bottom of the chassis under the rear drive shaft.

-Zack

	(#3)
Kcaz25 RC-Monster Titanium Offline Posts: 1,419 Join Date: Dec 2008 Location: Louisville, KY	06.23.2012, 10:49 AM I sortof hate to fully reveal what I'm working on before I'm finished but I need help. Now, no wiring has been done. I have to shorten(inches!) and route the wires all of them and mount the RX. Also some of the screws are mocked up and are loose. So what do you think about this? Obviously I am wanting to go under the rear drive shaft. It has enough clearance surprisingly. The wires pretty much have to come out of the ESC at a 90 then go down at like another 90 then go straight to the motor along the bottom of the chassis under the rear drive shaft. -Zack Last edited by Kcaz25; 06.23.2012 at 10:53 AM.