**My FLM CCNeu Maxx Nearly Completed**

[Kcaz25]

I sortof hate to fully reveal what I'm working on before I'm finished but I need help. Now, no wiring has been done. I have to shorten(inches!) and route the wires all of them and mount the RX. Also some of the screws are mocked up and are loose. So what do you think about this?












Obviously I am wanting to go under the rear drive shaft. It has enough clearance surprisingly. The wires pretty much have to come out of the ESC at a 90 then go down at like another 90 then go straight to the motor along the bottom of the chassis under the rear drive shaft.

-Zack

[ANGRY-ALIEN]

Hey Zack, see the example below... I see no real issues with you making the connectors 90° for your application... just make sure they are insulated well after you are done...





taken from: Losi Brushless buggy tips

Alien