|
08.06.2006, 08:16 PM
I run the dogbone conversion in my Rustler, and haven't had any problems with it handling the power. However, after a while the dogbone cups (axle and diff output ends) to end up with notches in them. This is with a Feigao 540 12s (3000 kv) and a Mamba Max 4600 motor, both on 4s Lipo.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|