Can i make a e-revo transmission fit on a nitro revo chassis?

[Hockeyplaya20]

Yes, i know that the holes are off, because they are 2 different transmissions. So i figured, ill cut a big piece of metal and screw it on. Then i would measure how much i would need to cut. And cut a big square in the middle of the transmission. Then drill new holes. If this did work, would anything else be a problem fitting?
Thanks :)

[brushlessboy16]

you might want to reword what your saying... cuz i have no idea what your talking about

[Hockeyplaya20]

ok, fixed the title :)

[Hockeyplaya20]

wow, im dumb... i figured ill go and try to make this mount in 1 shot deal. i cut the alum and everything. To find out it doesn't fit. i just realized i should have used some clear plastic as a template...

[magman]

I did it to my 3.3 Revo and put the 3905 trans. in...simple to do....and yes a template is a must!

[Hockeyplaya20]

thanks, trying to figure out where to put stuff now, esc where old engine mount was, battery on side (make a holder), and rx in the middle (im mounting the motor in the front making a gap in the middle.)
Would you happen to have any pics?

[Hockeyplaya20]

After making a template i finally got a outline!! :)
The holes match up perfect!!!!
So next step, cut along inside line to make hole for tranny to get in
side 1

side 2