 |
|
|
|
 |
 |
need help with measuring for center shafts |
 |
|
 |
|
(#1)
|
|
Guest
Posts: n/a
|
need help with measuring for center shafts -
05.15.2009, 12:57 PM
I need a set of center shafts for my Mutant Maxx build. But I dont know how to measure for them. Do I measure end to end of the shaft or center to center of cross pins. Any help would be greatly appreciated
|
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
working on a brushless for my wheelchair.....
Offline
Posts: 4,890
Join Date: Mar 2007
Location: minnesnowta
|
05.15.2009, 03:23 PM
i would use metric measurement from pin to pin
It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper. |
|
|
|
|
|
|
|
|
|
|
|
|
(#3)
|
|
Guest
Posts: n/a
|
05.15.2009, 07:55 PM
Now do I measure from center of each cup? I need to know basically when I buy a 120mm dogbone are the cross pins 120mm apart or is the dogbone end to end 120mm
|
|
|
|
|
|
|
|
|
|
|
|
|
(#4)
|
|
working on a brushless for my wheelchair.....
Offline
Posts: 4,890
Join Date: Mar 2007
Location: minnesnowta
|
05.15.2009, 08:42 PM
depends on manufacturer
It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper. |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
