Castle phoenix 110

Is this controller could be use with a pistol type radio without any mod or pixstix cable???
I think i'll order one for my e-revo.

[jzemaxx]

I had to use the pixstix to get mine to work with the pistol grip.

[Nick]

Why can't pistol grips be used with this? :S

[lutach]

Originally Posted by Nick

Why can't pistol grips be used with this? :S

It doen't have neutral. I didn't use the pixstix, but I had to change my trim and sub trim to make it work.

[BrianG]

Can you explain exactly what settings you used lutach? I'm sure I can figure it out, but why "re-invent the wheel"?

[lutach]

Originally Posted by BrianG

Can you explain exactly what settings you used lutach? I'm sure I can figure it out, but why "re-invent the wheel"?

To enter program mode in the HV110 I left the setting on my radio as is (TH Trim 50/50). After programming was done, I set the trim to -100 and the sub trim to max for brake. You will have to make little adjustments to match the throttle so when you give some throttle it will not have a long neutral range. Just have 2 model open on your radio. One for running the vehicle and one for programming the controller. Make sure brake is disabled on your ESC.

Is this a reliable controlller and this will be good for my revo with a Neu 1515 1Y on 4s li-po?

Thank you!

[Nick]

Is this designed for a plane/boat I take it?

It has break but we can't use it on Trucks (mechanical required) nor does it like Pistol Grip so much? Sounds like a pain, shame there isn't any other alternatives to running 12s! :(

Originally Posted by lutach

To enter program mode in the HV110 I left the setting on my radio as is (TH Trim 50/50). After programming was done, I set the trim to -100 and the sub trim to max for brake. You will have to make little adjustments to match the throttle so when you give some throttle it will not have a long neutral range. Just have 2 model open on your radio. One for running the vehicle and one for programming the controller. Make sure brake is disabled on your ESC.

Could you explain me little better please!!! about the trime, 50/50, -100 etc..... This is on trottle trim??
Please explain more in details please!

Thank you very much!

[lutach]

Originally Posted by david lamontagn

Could you explain me little better please!!! about the trime, 50/50, -100 etc..... This is on trottle trim??
Please explain more in details please!

Thank you very much!

This was a long time ago . If left my Throttle trim 50/50 the controller wouldn't arm until I pushed the throttle up (brake) and it recognized neutral. So what I did with the TH is set it all the way to negative 100 (JR radio) as well as the sub trim 100% brake. After that, I brought the throttle trim back torwards positive slowly until the controller armed. Then I just adjusted the sub trim to lower the neutral range a little. It was a pain the first few times I tried it, but after messing with the throttle setting for a while that it what worked for me.