It's funny that the users guide mentions that the MMP is packaged with the CM-36 motors 4600Kv-9000Kv motors. I forsee a lot of 6S motor explosions. I know they are working on the new motors but the average joe is going to blow up some stuff. Ther is no mention of RPM limits or anything like that even though I know the motors have the cell count they can handle on the sticker, it's coming.
I think this is the one I am going to get but I'll wait for some lower Kv motors.
Jeff
The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product.
Hmmm, I'm salivating--a MMP on 6s with one of the 21.5 turn motors already on the market (until Castle comes out with something better:) )in the new 4wd Slash=lot's of fun!
Hmmm, I'm salivating--a MMP on 6s with one of the 21.5 turn motors already on the market (until Castle comes out with something better:) )in the new 4wd Slash=lot's of fun!
I did run such a setup in a Rustler, but forgot to datalog it. Motor used was an LRP 21.5(1800kv). I swapped out the 12.5MM rotor for the 14MM for some more torque.
I did run such a setup in a Rustler, but forgot to datalog it. Motor used was an LRP 21.5(1800kv). I swapped out the 12.5MM rotor for the 14MM for some more torque.
See that's why I always say datalog everything.
Jeff
The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product.
I'm game, got everything back together got the magnets mounted in the Diff and sensor installed but it it's as bad as the brushless rpm sensor. Also got the dogbones and steel out drives, so I won't be snapping axle stubs every launch.
Jeff
The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product.
I did run such a setup in a Rustler, but forgot to datalog it. Motor used was an LRP 21.5(1800kv). I swapped out the 12.5MM rotor for the 14MM for some more torque.
How about your subjective data-logging?
How did it run?