I think the revo is done...

[jhautz]

OK. I think Ive finished the brushless revo Ive been working on. I'm looking for feedback on the setup. Anyone see any major setup issues with this. Just looking for some input from some of you who have already been there/done that.

Here is what I did:

-Gorillamaxx G2R
-MIP CVDs
-Emaxx Tranny (right now stock w/2 speed using the mini 2060 servo. see pics)
-Feigao 9XL
-Quark Monster Pro 125B ESC
-Robinson Dual Disk Slipper Geared 66/24
-Stock Steering servos (2)
-3s and 2s 8000mah Lipos plugged in series for 5s


Still to be done:
-Steel Idlers for the tranny
-maybe single speed conversion (I'll see after I run it for a while)
-Possibly a small fan on the esc
-Upgrade servos to Hitec 5925MGs (I had one already so I went cheap and just ordered a second one thats not in yet) They should be more than sufficient. 130oz each and .08sec speeds.


I think its a pretty standard setup as far a this forum is concerned. I was looking for some parts at the LHS earlier today and was describing what I was building and the way the guys there sounded it was like I was putting a man on the moon. I brought it in from the car to show them. They were pretty amazed. They hadn't seen anything like this in there. Just a few brushless emaxx's (and most of those Novaks)

If anyone sees anything that I need to do to make it better please chime in. I'm gonna take it out his weekend for a maiden voyage and any tweaks I can do before then would be good.

BTW: Thanks to all of you guys on this forum for all of the input and help with getting this all together. You have already provided a wealth of knowledge to me.