RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Revo
Reload this Page Revo Truggy

Reply
Page 1 of 5 1 23 Last »
 
Thread Tools Rate Thread Display Modes
Revo Truggy
Old
  (#1)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
Revo Truggy - 03.16.2009, 03:53 PM
Here is my revo MT/Truggy. Perfect weight distribution....

Tranny is set backwards for the motor to hang forward to hang the weight towards the front. With twin 3's its perfect 50/50. Truck runs 39mph on 3S and after 30min run, the motor is 110-115 and ESC is 101-105. Awesome setup....weighs 9.5lbs exact without batts.
Attached Thumbnails
Click image for larger version Name: IMG00098.jpg Views: 1709 Size: 33.7 KB ID: 6611   Click image for larger version Name: IMG00099.jpg Views: 1339 Size: 28.9 KB ID: 6612   Click image for larger version Name: IMG00100.jpg Views: 1486 Size: 34.6 KB ID: 6613  


Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Old
  (#2)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
03.16.2009, 07:24 PM
Looking good! Are you still running 4wd.? If so, can you snap a pic. of how you mounted the trans.... I am in the process of converting my 3.3 Revo and I am looking for new ideas....

Thanks!

1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
Last edited by magman; 03.16.2009 at 07:30 PM.
   
Reply With Quote
Old
  (#3)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
03.16.2009, 08:07 PM
Yes 4wd...using emaxx driveshaft.

Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Old
  (#4)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
03.16.2009, 08:21 PM
How was mounting it...problematic or simple? I like the idea...it is based on the GR3 chassis, but at a fraction of the cost!

1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
Last edited by magman; 03.16.2009 at 08:22 PM.
   
Reply With Quote
Old
  (#5)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
03.16.2009, 10:29 PM
Just made a custom mount under to bolt the trans to on one side and bolted the other side to the factory frame. Took it to the track today...wow. Working on the suspension a little more to tweak some bounce out of it. Since it came out ligther then expected, the suspension was setup for heavier setup.

Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Old
  (#6)
mopar1994
RC-Monster Carbon Fiber
 
mopar1994's Avatar
 
Offline
Posts: 123
Join Date: Mar 2009
Location: Michigan
03.17.2009, 07:42 PM
is that the e-revo tranny? did you have to drill new holes in the chassis to mount it? and i would also like to see a pic of the bottom
   
Reply With Quote
Old
  (#7)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
03.17.2009, 07:49 PM
No...emaxx 3905 transmission.

Pics coming

Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Old
  (#8)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
03.17.2009, 07:58 PM
Would this trans. set up work on my Revo chassis?

http://www.rc-monster.com/proddetail...MX07-TR&cat=17

I like your idea a lot and am considering doing this mod.

1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
   
Reply With Quote
Old
  (#9)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
03.17.2009, 08:20 PM
You can see I run bolts through the frame and the bracket and sandwich the trans in. It won't move not one bit. Ran it at the track yesterday for over 2 hours. Absolutely ran away from a E-revo that was with me at the track with the same basic setup. Its just much lighter on its feet and handles alot better. Also because its a lightweight setup I was able to gear it quite aggressively on lower voltage. Motor, controller and batteries have yet to go over 120. That was over an hour of laps...non-stop, just swap batteries and go. Running 10,000 mah so runtimes are LONG.
Attached Thumbnails
Click image for larger version Name: IMG00103.jpg Views: 1037 Size: 28.1 KB ID: 6621   Click image for larger version Name: IMG00104.jpg Views: 873 Size: 27.6 KB ID: 6622   Click image for larger version Name: IMG00105.jpg Views: 2559 Size: 30.9 KB ID: 6623  


Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Old
  (#10)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
03.17.2009, 08:11 PM
Probably would, but I like the 3905 trans since it places the motor in the middle

Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Old
  (#11)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
03.17.2009, 08:13 PM
I forgot about that....good point.

1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
   
Reply With Quote
Old
  (#12)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
03.17.2009, 08:23 PM
Did you do any mods to your trans?

1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
   
Reply With Quote
Old
  (#13)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
03.17.2009, 08:26 PM
nope....the 3905 tranny is brushless ready. So far its bulletproof. Ran it on 5S last night for giggles....57mph on the GPS.

Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Old
  (#14)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
03.17.2009, 08:42 PM
Would it handle 6s...because that is what I will be using

1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
   
Reply With Quote
Old
  (#15)
jzemaxx
RC-Monster Aluminum
 
Offline
Posts: 944
Join Date: Jan 2008
Location: huntsville, AL
03.17.2009, 08:54 PM
No problem....

Serpent S811-E Tekin
Revo 3.3 BL- 1515 1Y
Mugen MBX6 NEU/MMM
Mugen MBX6-T NEU/MMM
Losi LST2.0 MT NEU/MMM
Losi 8T RTR 2.0 NEU/MMM
Losi 8T 2.0 NEU/MMM
Losi 8B-E 2.0 NEU/MMM
   
Reply With Quote
Reply
Page 1 of 5 1 23 Last »

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com

Contact Us - RC-Monster Store - Archive - Top