brushless set up help

[hummer_maxxer]

Hey guys im new here but i aint new to rc but kinde of new to brushless, i got a hv maxx for my e-maxx and love it. And I was just wondering if this motor and esc would properly work together and how many cells i would need to use, and if there anything i should know about the motor and esc, like do they have a bad reputation ???

nemisis 10L brushless motor
BK warrior 7018 brushless esc

thanks

[neweuser]

What are you going to use it in?

If it is a maxx, you'd be better off with an XL feigo 540C motor and a 9920. It 'll run a lot cooler. An L motor will tend to get hot, for example,

Like 14 cells, go 7xl or 8xl with the 9920.

[hummer_maxxer]

well im asking about this set up cause im getting i a good deal on it, i plan on putting it in my xxx-t for abit then im gona put it into a maxx

[jhautz]

To be honest that not a very good system for either truck you are planning to use it in. Th 10L is to big and low KV for the XXX-T, and the 7020 is to small for the e-maxx.

I'd pass on that setup and spend a couple extra bucks and get something that is right for the truck you want to run it in.

[hummer_maxxer]

ok, I see, what do you mean about the 7020 being to small for a e-maxx??? and also i whant a motor with lots of torque for my xxx-t and its only gona be in there for a couple weeks, then its going into my brother maxx mudder project