Hot deals on Neu 1521's, 1515's

Originally Posted by MetalMan

I bought the 1521/2Y

lol..well that means I will just have to trade mine for the 2215 2y on OSE

hes in dire need for 1521/1Y

[doo540]

He must not want one to bad, I pm'ed yesterday that I had 2 1521 1y for sale with no reply at all.

I talk to him twice he wants to trade but he is from australia and only has 4 posts at OSE
So I asked for some rating somewhere or he would have to ship first

Havntt heard from him since.....LOL

Originally Posted by doo540

He must not want one to bad, I pm'ed yesterday that I had 2 1521 1y for sale with no reply at all.

[doo540]

Australia, I'm out, thats got to be some killer shipping prices. haha

[nitrostarter]

Yes it is. I did it one time, and never again....

well hes shipping me the 2215 sat morning
as far as shipping to australia

trading a $135 motor for a $450 plus a cooling can....I'll send to australia as many times as they want...

[MetalMan]

Got my motor today! It's nice having Neu about a 1.5 hour drive away.




There isn't really even a single scratch. The shaft has 2 flat spots, but that's the only thing wrong that I can tell. Also, the rear endbell is held on by 4 screws, and the front is held on by 1.

[BL_RV0]

Is having 2 flat spots a problem? Why?

Originally Posted by BL_RV0

Is having 2 flat spots a problem? Why?

lol ya he aint going to break that 8mm shaft with 4 flat spots on it

[lincpimp]

Originally Posted by bustitup

lol ya he aint going to break that 8mm shaft with 4 flat spots on it

I have a 8mm shaft 1527 that was in a jet edf and crashed at 150mph... Still runs true and does not have any issues. I doubt that you could ever damage that shaft easily...

[snellemin]

That is one thick shaft you got there man.

[BL_RV0]

I did break the shaft on my medusa, but that's only 5mm.

[Finnster]

Originally Posted by snellemin

That is one thick shaft you got there man.

lol...

I picked up the bantam charger and a couple batts. 2 of my 5S zippies have lost a cell, and HC no longer has zippy-H's to even replace them with. Crappy cheap ass zippies!

in the end, I have only paid $20 more for ea of the Neu lipos I have then I paid for the Zips. Better balancing and C rating to boot! Yeah Neu

Doo540, I thought you weren't selling that 1521 1y anymore?

[MetalMan]

Originally Posted by BL_RV0

Is having 2 flat spots a problem? Why?

One flat spot looks a lot cleaner than 2 Though there's nothing wrong with it per se.

Instead of having the shaft turned down to 5mm (maybe I like it thick ) I'm gonna try to set up my XLB with a 9mm wide plastic spur gear, along with a pinion of matching width.

[doo540]

Fin
I wasn't going to sell it but I just picked up 3 more Neu's so....I know have more motors then trucks. Send me a pm and I will send you a full list of what motors I have.


Has anyone run a Neu Helicopter motor in there trucks yet? It has a built in fan and the wires come out of the front side of the can, 1515H 2.5D I might give it a ride in one of my LST2.