 |
|
|
|
|
|
 |
 |
 |
|
 |
|
(#16)
|
|
RC Monster, the Final Frontier
Offline
Posts: 3,379
Join Date: Feb 2006
Location: Minnesota
|
09.16.2006, 12:06 PM
I had issues with my MIP's fitting well with the g3, they were not QUITE long enough it seemed, i would've had to adjust my pillowballs way in for them to work well. So i went ue cuz they were a tad longer and fit so much better.
|
 |
|
 |
 |
 |
|
|
|
|
|
|
(#17)
|
|
RC-Monster Admin
Offline
Posts: 10,480
Join Date: Feb 2005
|
09.16.2006, 05:10 PM
Mips should work You can use an M6X1mm thick spacer behind the bearing and the driveshaft on the opposite side of the wheel.
|
|
|
|
|
|
|
|
|
|
|
|
|
(#18)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 147
Join Date: May 2006
Location: Houston
|
09.16.2006, 10:25 PM
mip's worked fine for me
|
 |
|
|
|
|
|
|
|
|
|
|
(#19)
|
|
Brushless G-maxx
Offline
Posts: 378
Join Date: Jan 2006
Location: Denmark
|
09.17.2006, 01:11 AM
Ok, thanks for your help guys. I think I will go for the G3.
|
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
