Problem LI-PO cut-off - RC-Monster Forums

		RC-Monster Forums > Support Forums > Brushless
Problem LI-PO cut-off

Rate Thread

Prev

Previous Post

Next Post

Next

	(#7)
squeeforever RC-Monster Mod Offline Posts: 6,254 Join Date: May 2005 Location: Baton Rouge	11.16.2005, 04:29 PM what about then you dont want to run lipo and you wanna run nimh? if i were to use something like that i would want it soldered. what would i do if i was to run nimh? just unplug i from the esc and the reciever and the esc up to the reciever like normal?

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com