 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
BMW M Power!
Offline
Posts: 1,910
Join Date: Jan 2006
Location: SoCal
|
10.23.2007, 11:31 PM
I don't see any reason not - they are just wires...they are attached to your motor, but are otherwise just wires...
CRT .5: 7075 Ext Chassis, LMT1930/7, FP 25C 3S Lipos, MM |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
Guest
Posts: n/a
|
10.23.2007, 11:53 PM
Yes, but this wire seem to have solder on it i suppose because they are very hard to bend.
So i'll bend it and if i don't have any longer wire, i'll solder bullet conector on it, this will gie me an extra 1/2 inch. I'll don't want to use connector between controller and motor, prefer to direct solder, but if the wires is not long enough, i'll don't have the choice. Thank you! |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
