Can i bend wire on Neu motor?

[glassdoctor]

I have bent mine 90* but as mentioned... I would not reccomend repeated bends back and forth. I have bent mine back a couple times when I swapped vehicles, etc. But I don't like doing that.

Neu does also say to not put a lot of stress on the wires, to prevent damage to the windings. Just a general caution... so keep that in mind when bending them. I used a pair of needle nose to hold the wire close to the can, rather than just bending them without any support.

[rchippie]

I used a pair of needle nose to hold the wire close to the can, rather than just bending them without any support.

I did the same thing to mine.