Lehner motor bearings

[sikeston34m]

I wonder if Red Loctite would work for something like that?

The stuff is like "steel glue" for bearing races and threads. It also requires 500 degrees farenheit to loosen it's bond.

[lincpimp]

Not sure about loctite, it requires the absence of air to dry, correct? Or it is not very good at bridging gaps? I have had good luck with the jb weld and the surface was porus so hopefully it will work.

We will see how it goes with the new bearings. I think the new emaxx will get this motor on 5s and we will see how much better it is than the hacker c50.