Me and My Axi-Maxx Video's!

[suicideneil]

So you like the new firmware then I take it?....

[sikeston34m]

Originally Posted by suicideneil

So you like the new firmware then I take it?....

The new firmware is what this controller needed all the way along.

Castle needs to come out with some new advertising. It's VERY different and better now.

[sikeston34m]

Just a little additional information to pass along here.

I got a chance several days ago to run this with a couple of buddies of mine.

One of my friends had a stock E maxx 3905.
The other had a T maxx 2.5.

This of course pretty much smoked the stock E maxx, but to my surprise it also outran the T maxx.

It took the T maxx pretty badly on acceleration, but would also outrun it on top end. At least for the first half of the pack.

During the last half of the pack, top end was a VERY close match. I could still out accelerate him though.

[JERRY2KONE]

It is always nice when our elecronic monsters can hand the head of a nitro want-a-be me in a face to face match up. That project of yours has been quite an imspiration on here Sikes. We all wish that rewinding a motor like that was easier for all of us to do. You sure put a lot of work into that motor and getting that truck setup the way you have it now.

Good work in kicking T-Maxx butt.

[sikeston34m]

Originally Posted by JERRY2KONE

It is always nice when our elecronic monsters can hand the head of a nitro want-a-be me in a face to face match up. That project of yours has been quite an imspiration on here Sikes. We all wish that rewinding a motor like that was easier for all of us to do. You sure put a lot of work into that motor and getting that truck setup the way you have it now.

Good work in kicking T-Maxx butt.

Thank you Jerry!

This is a stock "out of the box" AXI 2826/8. I didn't rewind this one or pull any special tricks to make it work.

Only thing, Mod 1 Gears! 22 tooth RCM pinion on the motor and a Revo 40 tooth Mod 1 Spur gear.