Brushless, Lipo Cr-01 build

[rootar]

from what i understand its normal to see 2hour runtimes when using ultra high turn crawler motors and high capacity sub-c or lipos, most guys run the 2/3a 1500 cells and can get 30 minutes out of these, very surprising...... and with 13mph and brushless linc if you get hung up on a rock you can just back up and launch that thing over it lol thats wild

[lincpimp]

Originally Posted by rootar

from what i understand its normal to see 2hour runtimes when using ultra high turn crawler motors and high capacity sub-c or lipos, most guys run the 2/3a 1500 cells and can get 30 minutes out of these, very surprising...... and with 13mph and brushless linc if you get hung up on a rock you can just back up and launch that thing over it lol thats wild

Yep, this chassis has great suspension, and can handle the incresed speed. I do a bit of scale jumping, and it is plenty strong to handle 1ft jumps, and the crashes. It is alot of fun, and a welcome change of pace.

[BL_RV0]

So you have it running?

[lincpimp]

Originally Posted by BL_RV0

So you have it running?

Me?

The cr01 runs fine. I have about 1.5hrs on it.

[BL_RV0]

Then where are the Damn pics?

[lincpimp]

Originally Posted by BL_RV0

Then where are the Damn pics?

Calm down Beavis

It looks just the same, save for the deans plug. I painted the body, but need to put the body posts together and fit it up. I run everything with the body off, this lowers the cg a bit and limits the rollovers. I do need to finish it.

I was contemplating putting the 6.5r hv motor in it, just on 2s. And gear it up to the 25t pinion max. It would have tons of torque! We will see...

[BL_RV0]

That would be cool. A scaler doing a wheelie would be neato.