help with timing on a Medusa 36-60-2000 v2

Originally Posted by ogrfre01

I have a Losi 8ight with:

-Esc: CC Mamba max
-Motor: Medusa 36-60-2000 v2
-Battery: Polyquest 4S 5000mah
-Gearing: 14/48
-CC BEC
-RCM battery tray and motormount

As the Medusa seems quite simular to the Neu, im woundering about the settings for the timing, should it be "0"? I now have it on default (10) and Punch control at (70) start power is default (Low)..... if i change the timing to 0, should i change something else? like punch control? start power?

I run my setups with timing at 0, increasing the timing increases performance with a brushless motor very little, but increases heat alot....its not a good trade off, punch control at 0 and in the Castle SW, I adjust the throttle curve instead of using the punch control

[ogrfre01]

azjc: thanks for the reply, but what about "start power"? (I just tried to set timing to lowest (0) and all cogging went away)

Originally Posted by ogrfre01

azjc: thanks for the reply, but what about "start power"? (I just tried to set timing to lowest (0) and all cogging went away)

I have start power low also...my Neu 1515/2.5d has all the power you might want, and I am thinking about adding a 2s pack in series with my 6s to give me me a 8s kick in the pants....

[ogrfre01]

Originally Posted by azjc

I have start power low also...my Neu 1515/2.5d has all the power you might want, and I am thinking about adding a 2s pack in series with my 6s to give me me a 8s kick in the pants....

8S
I am really pleased with my medusa.... i seems to have simular power to the Neu and doesnt run to hot either....