Would the Medusa 36-60-1500 be a good 6S motor?

[lincpimp]

It does reasonably well in my hyper8. I have that motor and the 1600 kv version. I will say that some sort of heatsink is a good idea. I plan to gear the 1600kv motor down and run it on 6s.

Although most seem to think that a 40k rpm max is a good idea, higher end motors seem to work well closer to 50k rpm. I have run a variety of motors that high. Usually 3000kv plus motors on 4s. Hacker c50 8l, Hacker c50 maxx, plett maxx with and w/o fans, nd a few others. Feigao motors do not like over about 35k rpms. I have a few more motors that I plan to use on 4s that will stay around 50k rpm max...

You should be ok with the 1500kv on 6s...

[lutach]

Yes, I run a 1521/1Y (1577Kv) with 6S in my BPP truggy. I also run it on 5S and did do a few 10S runs just because I was curious . BTW, I'm going to use lincpimp's B50-11XL (1435Kv) with 6S as well.

[lincpimp]

Originally Posted by lutach

Yes, I run a 1521/1Y (1577Kv) with 6S in my BPP truggy. I also run it on 5S and did do a few 10S runs just because I was curious . BTW, I'm going to use lincpimp's B50-11XL (1435Kv) with 6S as well.

I just got the c50 11xl in the mail. I may run it in my savage on 8s... May produce a bit more power than the 14xl feigao. I will most likely put it in the hyper st with a MMM on 6s...