Zippy-R Pack dimensions

[spaz163]

Well it depends where you measure to. I just went and measured mine and I came up with 165mm (6.5") if you measure from the end of the pack to in between the balance and charge plugs. But if I measure from the end of the pack to the end of the shrink wrap around the charge plug leads I get 177mm (7").

So if you were using a low tray so that the balance and charge leads could just hang over the end of the tray, I would say 165mm and then use a velcro strap down the length of the pack in between the 2 plugs.

I have not been able to run this pack yet because of a faulty charger I recieved so I cannot give you any performance data on it yet. Oh and I have the 4s 4800 Zippy-R.

Originally Posted by spaz163

Well it depends where you measure to. I just went and measured mine and I came up with 165mm (6.5") if you measure from the end of the pack to in between the balance and charge plugs. But if I measure from the end of the pack to the end of the shrink wrap around the charge plug leads I get 177mm (7").

So if you were using a low tray so that the balance and charge leads could just hang over the end of the tray, I would say 165mm and then use a velcro strap down the length of the pack in between the 2 plugs.

I have not been able to run this pack yet because of a faulty charger I recieved so I cannot give you any performance data on it yet. Oh and I have the 4s 4800 Zippy-R.

Thanks, that's the exact answer I was looking for.
It sounds like they are the exact dimensions of my TP packs. I am also going to be getting the 4s 4800mah. :)
Thanks again.

[tc3_racer_001]

so will this fit in a tray designed for the new enderland packs? (168mm compared to zippy's 170mm... personally i think they are using similar cells.

Originally Posted by tc3_racer_001

so will this fit in a tray designed for the new enderland packs? (168mm compared to zippy's 170mm... personally i think they are using similar cells.

Wont fit because they are 50m wide.
I just had Mike make me two custom trays so i could fit my new PQ pack ( Enelrand cells ) and Zippy packs.

The Zippy-Rs are stated to be 45mm wide...
Are they really 50mm?

Originally Posted by ffactory666

Wont fit because they are 50m wide.
I just had Mike make me two custom trays so i could fit my new PQ pack ( Enelrand cells ) and Zippy packs.

My bad , sorry . Mine are the H packs not R

Originally Posted by spaz163

Well it depends where you measure to. I just went and measured mine and I came up with 165mm (6.5") if you measure from the end of the pack to in between the balance and charge plugs. But if I measure from the end of the pack to the end of the shrink wrap around the charge plug leads I get 177mm (7").

So if you were using a low tray so that the balance and charge leads could just hang over the end of the tray, I would say 165mm and then use a velcro strap down the length of the pack in between the 2 plugs.

I have not been able to run this pack yet because of a faulty charger I recieved so I cannot give you any performance data on it yet. Oh and I have the 4s 4800 Zippy-R.

So, you measured till the blue stripe, right? That was 165mm? But can you say me the length of the pack from the end to that black cell? ( Look picture )

Ty in advance!

Originally Posted by Byte

So, you measured till the blue stripe, right? That was 165mm? But can you say me the length of the pack from the end to that black cell? ( Look picture )

Ty in advance!

I'm fairly sure that he meant that the red stripe was 165mm long, and to the blue stripe it was 177mm long.

Originally Posted by E-Traxxer

I'm fairly sure that he meant that the red stripe was 165mm long, and to the blue stripe it was 177mm long.

Ok ty!

Sorry, but my Englisch is not that good..


Anyway.. It won't fit in my E-Firestorm or Rustler VXL :(

[spaz163]

From the end of the pack to where you can see that black stuff in between the two leads, I measured 165mm. But from the end of the pack to where you have your blue line drawn, I measured 177mm.

[tc3_racer_001]

so they are the same dimensions as the new poly quest packs? (i.e. if i buy a 168x 45m box it will fit? thanks for the help guys!

(so far its looking VERY good.)