Largest possible motor for CNC stampede/rustler transmission case?

Originally Posted by DwightSchrute

i've run the 1515 1 Y smooth can in my rustler with 6S...if you run the extended rear a- arms w/or in addition to integy 17mm adapters, there isn't even a wire clearance issue.

i however, don't really recommend a 1515 for the rustler....it's like putting a jet engine in a honda s2000.

Ouch!!!!!!!! you're crazy man The stock slidder drive shaft should take a beat

[DwightSchrute]

Originally Posted by david lamontagn

Ouch!!!!!!!! you're crazy man The stock slidder drive shaft should take a beat

it didn't stay in the rustler for long ...although i used flm cvds.

the stock drive shafts got ripped on first throttle contact with the neu, and was really the only weak part in the drivetrain.