Direct servo power ?

[Arct1k]

pretty much but generally to an ubec rather than directly to the battery.

When i did this mod on my clod I removed the signal wire from the servo plug and instered it into a spare male plug - each servo then has two plugs, one with + and - and one with signal.

The signal plugs go to the rx.

For the + and - leads i created a 3 to 1 y adapter - plugging in the two servos and the ubec - the two servos are then powered directly from the ubec.

For the output of the y i left only the - which plugged into the rx to provide a common ground.

hope that makes sense.

[KaztheMinotaur]

You lost me on the last part. If you didn't have a +, from the Y, going into the RX then how did it get power?