grinding 6mm shaft to 5mm? - RC-Monster Forums

		RC-Monster Forums > Support Forums > Brushless
grinding 6mm shaft to 5mm?

Reply

Rate Thread

	(#1)
_paralyzed_ working on a brushless for my wheelchair..... Offline Posts: 4,890 Join Date: Mar 2007 Location: minnesnowta	05.31.2009, 08:39 PM you can run it while filing it, or run it and use a dremel against it. you're only taking off 1mm, and if you run the motor while grinding it its almost impossible to grind it off center. also kershawdesigns sells 6mm pinions _______________________________________ It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper.

Reply

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com