1/16 Mini E-Revo - Top Speed Build

[Over_revO]

Thats a very good news Kazuaki :)
I will wait and see what kind of speed you will get out of it.


150$ is a lot of money for an incomplete kit, and even if the chassis was complete. But it is now available for everyone so now i retire my comment , even though it was not that much of a big issue for me, just a comment i should have not posted...
was not trying to start anything.... i apologize if it look like that :)

Im sure you will sell them without trouble.

Cant wait to hear about your results

:)

[kazuaki]

Over_revO, I'm just playing around...definitely not upset

[TexasSP]

Originally Posted by Over_revO

Thats a very good news Kazuaki :)
I will wait and see what kind of speed you will get out of it.


150$ is a lot of money for an incomplete kit, and even if the chassis was complete. But it is now available for everyone so now i retire my comment , even though it was not that much of a big issue for me, just a comment i should have not posted...
was not trying to start anything.... i apologize if it look like that :)

Im sure you will sell them without trouble.

Cant wait to hear about your results

:)

For a single run machine shop price which is obviously what he has posted the 150 for the part is not bad at all. If it were a production run type thing I would expect better pricing but it is what it is.

[kazuaki]

In all honesty, I set that price and the long lead time hoping nobody would want one It's just not the business I want to be in. Let me make some speed runs on this and verify that it does what it's supposed to. Then I will start a new thread gauging interest. As most of you know, the price would be partially determined by the number of units. The pieces are cut on a waterjet, so the setup work is minimal. Of course, the designed needs to be compensated for his efforts as well

I should have some preliminary spped runs done this week, now that my ESC is finally here.