 |
|
|
|
 |
 |
 |
|
 |
|
(#11)
|
|
RC-Monster Titanium
Offline
Posts: 1,609
Join Date: Aug 2008
Location: Bozeman, Montana
|
12.11.2009, 05:21 PM
If we were to harden them at home (heat until cherry red then quench in used oil) would they be any better or would that make them worse? I ran an RC-M pinion for about 8 months before changing it out and there's a slight bit of wear on it (just from tons of use), I need something that's going to last as well as or close to an RC-M pinion.
Mike: Any chances of getting us some 6mm bore Mod 1 pinions? |
  |
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
