Hailing 8T 2.0 Drivers

Originally Posted by Ellwood BL

Cadima, I have a 8T 2.0 that I converted and previously had a 8T 1.0 that was converted also. I will say that you are correct about the servo saver spring being too strong. I have seen a suggestion about using a Fioroni servo saver spring from Amain hobbies. I am going to try it since I destroyed the gears twice in an AE XP DS1015, which is supposed to be pretty good..

I threw in a 1.0 spring and it seems a bit too soft. I also rounded off the peak of the cam surfaces on the saver arms so they'd roll up on each other easier. We'll see...........

[bryan]

First, I would,again and again. Your also gonna want to get some 1.0 lower shock ends "call Bill at horizon", he will probrably just send you some. You may also want to get some aftermarket rear hubs,"for a bigger outer bearing" i use the integy.Smart diffs. "YES" ,but that is a whole other thread.