New Anodized RCM Muggy Mount

[RC-Monster Mike]

Interesting - this is definately NOT the case with any one I have seen. I know that the holes are pretty true, so if the bearing is even slightly out of alignment it will appear as though it doesn't fit, but every one I just test fit(after reading, I checked a handful of the remaining stock), the bearing presses in perfectly(slight drag, but no excess force required to install). I do apologize if you got a tight bearing hole, but I assure you that it is a very rare occurrence and not indicative of the anodized mount, as the Muggy mounts have been anodized for a while now. :)

[JThiessen]

That's good to hear. Just wanted to give you a heads up just in case. This one would have been a definite press fit scenario.