Center slipper setup????

Thanks but I already knew about the Slipperantial. Not exactly what I am after. Don't want the diff part of it, just the slipper. I really wish somebody made something like the unit in the HPI Bullet but in 1/8th size. I am sure that I not the only one that would like to see something like that.

[ANGRY-ALIEN]

Hmmmm.. have you looked at the OFNA Monster Pirate slipper?

BANG!!!!!! Spot on what I need. That is 1/8th setup? By that would it work in a 12 pound truggy without melting? I think this might just work out. Thanks a lot Alien.



Sour gear might be a bit on the large side but I can just get a bigger pinion. A lot bigger pinion. LOL

[ANGRY-ALIEN]

You are welcome... I am assuming this will be a brushless project... If it is, you might a little more wear than normal, but it should handle the extra torque well...

Have a look at this page: Candymans Maxx Bling

Alien