mamba monster issue

[CerberusVI]

It did the same with the truggy tires, forgot to add that. I'm geared 12/51 and I have no smaller pinions, my diff ratio is 3.308, weigh maybe 10lbs? And iirc geared for low 40s

I'll try start power and then try a different firmware when I get off work tonight. Also I ran the turnigy motor on 5s and my truck is way to big for that little of a motor is why it got hot, I was just testing out the system and new back up motor.

[_paralyzed_]

I'd double check all of your solder connections. One bad solder joint can cause these problems.

Could very well be as the 1520 would pull a lot more current and highlight any bad solder joints...

[CerberusVI]

Everything is new unmolested castle stuff, but I will check the solder on the motor wires also.

Thanks for the input!