traxxas sliders with g2r single speed?

[squeeforever]

Starscream, got any recent pictures of your G2R?

[starscream]

I' dont right now but I can get some.
I've recently added the Sensor to my racing arsenal
I've got heat sensors on my esc and motor as well as a voltage sensor :018:
The Sensor sure looks funny but I raced with it last weekend and it feels great.

Sorry for highjackin the thread, I'll start another one with an update on the tmaxx3.3 G2R Highbrid

i'm trying to put together a parts list so anyone searching for this again can have an easier time... and i don't have to keep buying new parts... so starscream correct me if i'm wrong or let me know they are the right parts and the proper amounts...

2X emaxx yokes 4928X
2X revo centre half sharts 5455
2X revo u-joints 5452

[starscream]

Originally Posted by abiye

i'm trying to put together a parts list so anyone searching for this again can have an easier time... and i don't have to keep buying new parts... so starscream correct me if i'm wrong or let me know they are the right parts and the proper amounts...

2X emaxx yokes 4928X
2X revo centre half sharts 5455
2X revo u-joints 5452

Thats correct.
You'll also need spacers to go in between each e-clip (2mm washers prefereable but 3mm should work).

the revo yokes work as well actually and they are beefier so i went with those... the fron shaft poses a problem though... they are too short so i had to use to males and cut the yoke off the female half shaft and slide it over both males to make a long drive shaft... i actually bonded one of the males to the female and left the other male to slide in and out...