baja 5b bl

it has 4 motor wires to!!!! or does it not????

and yeh lol, i bet 100 bucks it pulls wheelies =P



EDIT, the e hammer is 2600 bucks!!! and yes its the motor u thought it was lol.. theres like 8 wires for it!

[BP-Revo]

Its 6. Thats actually standard on most Lehner motors now. Allows you to change between Delta and Wye connection.

Delta connection is the "standard" connection. Gives the rated KV, etc. Wye gives KV thats 1.73 times less than the rated KV. But it is more efficient and has more torque. In a way this allows you to have two motors in one. This is going to be like my backup for my CRT .5. If it is too fast I will go to Wye orientation, which will reduce KV and slow it down.

[Serum]

it's not said that it's more efficient bp.

The 3060/3080 motors of lehner have got 3 wires going to the speedo. but all the other wires/plugs that sit on the rear are for the Wye and Delta configuration.

LOL believe me i read ur thread bout all this lol

and i didnt know that tho, do u use all 6, or just 3?

[Serum]

Three, read my earlier post.

ooops, sorry didnt see that lol

how do u know what goes where to set it up right?

[Serum]

By looking here;

http://lehner-motoren.com/ms30.php?la=en

ohhh, ok thats cool... looks like a pita tho... lol to me ne ways

[steveo]

i think finedesighnrc.com is going to beat you to the punch, they just built a duratrax 1/5 bl truck 22 series lehner and 10s lipo and soon after same setup in 5b buggy check it out

[steveo]

no i'm sorry a 3040 series lehner motor

[Re~Mix]

I think if done right, each could work. However, the cheap resources that finedesign uses will never due such a conversion justice. A big motor like that deserves more than clamps as motor mounts.

[MetalMan]

I hope Chris will be at the RCX show. Then I can give him a piece of my mind! And if I see his (IMO) crappy conversions, I will point out the "crapiness" of them to passers-by.

[glassdoctor]

Ha ha... I can see it now... a spontaneous pick line forms in front of the FD booth... :D

[BrianG]

lol. Just bring a couple of your conversions to show people that there are better designs. :)

[MetalMan]

That would be nice. Mike needs to set up a booth at RCX! I could help him work it :). Hobby People is a major supporter of RCX, and is the hobby store chain that I work for. My boss (the manager) will be hosting the "Try Me" track, so myself and the other employees are going to be bugging him. It should be fun.