Integy bearings and UE 8mm cvds

Do the bearings supplied with the UE 8mm cvds fit in the integy knuckles? I'm wondering b/c on the rcmonster site it says that the integ knucks use 15 mm bearings, while UE's knuckles use 16mm. thanks

[Serum]

You won't be able to find any 'fair' priced 15 mm bearing with 8 mm holes. (at least, I couldn't) you see, it is not a standard size, so they are not produced in mass, unlike the 16x6/ 16x8 bearings..

Sorry for that.. I looked for them as well for quite some time, but the only ones that you can find are too expensive or not wide enough.

darn, thats what i get for getting integy...again

[Serum]

you got their 'racer X' copy?

[coolhandcountry]

I got the integy knuckles from mike. They have the 8mm bearing in them now. The older integy are different. I hope this helps you.

I had the bulkheads, you can figure out the rest of the story. The bulks bent where they meet the chassis.

Coolhand, i'm not quite sure what your saying, but I to bought these from mike. So do you run 8mm cvds?

[coolhandcountry]

I have a set of 8mm and 6 mm ue cvds. Both are run on integy knuckles.

[RC-Monster Mike]

The 8mm cvds are run inside Integy pro3 knuckles, which have a 16mm bearing.