My truck / one moretry

[neweuser]

Here ya go guys, let's hope it works!

http://livedigital.com/accounts/welcome/

[neweuser]

I think it did!!!!!!!!!!!!!!!!!!!!!!!!!! A lot more work needs to be done on it...but it still is fun. Haven't totally got it complete and runnin yet. Still need screws that will fit the strobe. 4-40's DO NOT work, but i think i know which to use.....3mm's should. Also still need a ubec...

[coolhandcountry]

I can't see the pic cause it say I am not a member.

[Sylvester]

Same here, it doesnt work.

[crazyjr]

sign up page here aswell

[neweuser]

darn, need to make them public...i'll get it in awhile...sorry.

[neweuser]

try this... emaxx.livedigital.com

[neweuser]

OK, try this... http://emaxx.livedigital.com/

[sjcrss]

looks good, but here's a suggestion......you should switch the bl controller with the receiver.....this will cut down on wire length ect.....but overal it looks great....good.. job

[Sylvester]

It works now! Nice truck! Very neat wiring!

[neweuser]

Thanks guys. How do like the mod mount job that i used for the controller!!! Does my parrallel look right? it seems two neg wires will be going to one battery? is that correct? I still need a ubec though!

[neweuser]

Also, the other question i have is, the wires that go into hte receiver. I'm not sure which ones the neg pos and so forth. i have orange, brown, and red think....so which way does the plug go into the reciever? Can you see it in the pics? Also, i pulled out the black jumper, do i need to do anything else to the controller?

[sjcrss]

your wires on the esc for the batteries looks correct....just make sure you have them like the following.....from the esc....black wire (-),(+)to(-),(+) red wire to esc......as for your other question....the brown wire should be in the rx the same way your servo wires are...ie...black wire on servo lead.....hope this helps....

[neweuser]

i'll check it out. i won't need to pull any wires from the connector as i pulled the jumper out right?

[sjcrss]

correct.....