Quark 125 - cutoff settings....

Wow, guess I'm hard on my packs. I use a 2.7v cuttoff, run my packs up to around 170*f, repeak them after balancing, and ding them or bow them a bit from makeshift straps. (Flew them into the ground at 80mph)

I have never lost a cell. I have every cell I ever bought and they all work. They just get replaced with better cells. At the rate of improvement, most of my retired cells probably have half of thier cycles left. This is Airplane, Helicopter, and 1/10 scale-1/8 scale off road.

I am very carefull to charge, and store my packs, and I keep tabs on packs and their performance. I keep tabs on balancing. I read stories to them about fast cars, and tuck them in at night. But once they are plugged in, I work them hard, till they dump. (my 1/10 scale doesnt even have a v. cut-off)

Havn't heard about the 3.2v cutoff for higher draw packs yet, I'm having good luck at 2.7v so far. (and Im not going for longevity at this point)