 |
|
|
|
|
|
 |
 |
 |
|
 |
|
(#20)
|
|
RC-Monster Admin
Offline
Posts: 14,609
Join Date: Nov 2005
Location: Des Moines, IA
|
08.24.2007, 03:36 PM
Put the whole ESC in the freezer for about 20 minutes. Then, GENTLY use a flat bladed screwdriver and SLOWLY pry between one corner of the heatsink and the PCB. Breaking loose a corner is much easier than attacking it from one side.
Also, make sure that the screwdriver is not resting directly on any PCB traces or they may be damaged. Disclaimer: Doing this may damage FETs. I've pulled the heatsink off two MM's and done two Quarks and have had no problem, but the possibility of damage is there... |
  |
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
