E-maxx CVD's

[Ninmaxx]

Do I e-mail him when I'm going to order them?

[Ninmaxx]

With the 3.3 shafts will I have to use 6mm E-maxx yokes or will they just fit directly?

[mkrusedc]

Originally Posted by Ninmaxx

Do I e-mail him when I'm going to order them?

Yes. Better yet put under notes/special instructions when you order online.

[mkrusedc]

Originally Posted by Ninmaxx

With the 3.3 shafts will I have to use 6mm E-maxx yokes or will they just fit directly?

The output pin on the T-Maxx tranny is different then an E-Maxx. I don't remember the size. Maybe I can find it.

[Ninmaxx]

I think the t-maxx is 4mm and e-maxx is 6mm, How did you fit your 3.3 driveshafts on your maxx?

[mkrusedc]

I used the RC-Monster dog bones for the centers. For the out drives I used the 3.3 shafts. I also used RPM axles carriers and arms, and T-Maxx 3.3 turnuckles. With that setup I just swapped parts and did not have to do any modifications.

[Ninmaxx]

Are the outdrives on an E-maxx 4mm?

[mkrusedc]

Must be the 3.3 shafts fit without modification.

[Ninmaxx]

Ok sweet! That will work now but I still have to find out if the 3.3 shafts will fit the HB diff..

[mkrusedc]

Let me know because I'll be getting some also.
mark

[Ninmaxx]

Thanks and will do.

[mkrusedc]

I found the answer. You do have to do a modification:

http://www.rc-monster.com/forum/showthread.php?t=7249

[Ninmaxx]

Thanks for your help.