Making an esc better?

[GriffinRU]

• Sanding FET's for better adhesion and flatness
• Silver epoxy Top side of middle Fet's board
• Silver epoxy Bottom side of middle Fet's board
• Attach brass heatsink to top and bottom (Remove LED's)
• Solder Header to Top Fet's Board
• Solder new Caps to Top Fet's Board
• Check alignment of top and middle boards
• Apply heatsink grease to bottom Fet's of Top Fet's board
• Solder headers and caps, trim caps leads
• Attach brains pcb, trim header
• Prefinal view

Further steps will follow...


To suicideneil:
Why using bad motor when you can utilize better one, have you checked my thread about 7XL running on sensored mode, borrowing sensors from HV-Maxx motor?