Quote:
Originally Posted by MetalMan
That's totally normal. When the switch is turned on, the BEC is turned on. Without the BEC on, the ESC just sits idle since the brain circuitry isn't receiving any power. So when the BEC on one ESC is enabled, it basically powers up the other ESC's brain circuitry.
|
Ok, that makes sense. I figured it was normal because all of the smoke stayed on the inside. LOL
Quote:
Originally Posted by sikeston34m
In the dual brushless setup that I did awhile back, I lifted the red power wire from one of the ESC's. This way there was no feedback and no potential problems.
One BEC is plenty to carry your servos.
|
I'll do this to be on the safe side. Thanks guys!
Threaded Mode
