molding carbon fiber?

[pipeous]

A fellow rc'ers father showed me how to make carbon sheets. It was rather easy once he showed me. He had done fibreglass stuff and made boat hulls and such. It was always interesting going over for a chat and listen to him describe the methods and such. He explained a product he called peel and stick. it was a porous material for doing the inside of the hulls. they made a mould for the outside that used release wax and the inside this peel and stick stuff they squeeged the excess out. it left a rough finish inside though so you might not get the desired finish. I wish he still lived down the street so I could toss this thread at him to comment. he's retired and living up country now