MGM Low Voltage Cut Off - Owners READ

Very good, thank you!

[Topas]

You don´t have to wait for the reply. My information is correct and you will need the new cable. That is the reason why I post this information here in the forum. It will be easy for you to order this cable so they can send you the updated esc AND the cable...

Here is what Grisa from MGM had to say about the CC_03 cable.

"programming is make always via CC_02 cable. Only for update SW is necessary CC_03 cable.

Best regards,
Grisa"

Topas you are indeed correct.

Is somebody could tell me what's SW want mean??

[jacobsjo87]

SW= Software

As i've ever said, my english is poooooooooooooooooor

Thank you!

[Topas]

Today I received my mgm 22418 car esc. (I bought a new one) This one was shipped with sw V 3.21 .

Due to bad weather conditions I could try it in my new emaxx (motor : kontronik fun 600-25) for only 20 minutes or so. (at 16,8 V)

At first I had some problems in setting up the esc (setting max. break and max throttle + I didn´t know if I should enable freewheel).
Furthermore I noticed some breaking problems with the default car setting. I drove the emaxx with medium speed and tried to stop (max break) but the car increased the speed and was stopped by the front wheel of my car ...! After changing the deceleration value to very hard1 2,3s the problem was gone.

I have to install my eagletree logger to support my feeling that the motor runs hotter on the mgm as on the kontronik jazz 80 but there was no cogging and the motor ran very smooth.