Hellfire conversion

[Arct1k]

Not on hobbycity but I did on my thread...

http://www.rc-monster.com/forum/showthread.php?t=10618

I always knew that it was a bit small and 16.5v (5s A123) would be a bit low kv but was starting there before taxing my mm on 6S a123.

I can take some pics of what is left but the internal wiring is REALLY thin. I think in the end it cooked itself and the insulation on the woring broke down and it shorted.

Sods law I was just bringing it back for a temp check when it gave out. But after a 2 mins back and forth in basement it was too hot for finger 120+.