OutRunner Raze

[brushlessboy16]

Hey guys just a little update.. With the raze being out of running condition, im taking the time to make a nice motor mount out of reall angle aluminum... the last one was some 1.5in flat stock bent over a jack stand.. Mind you the sole purpose of the maiden voyage was to wreck my Freind Josh's Nitro Rs4 ev0+.. I did. now to make the arrangements final. :P
I am also installing my spare Hs-311 servo... its a standard plastic geared servo but it works for what i need.


I also orded the following this morning during Mech Drawing class :LOL:

1. Raze center shaft set
2. Warhead center shaft set
3. C-hubs
4. Aluminum front knuckles
5. locknuts

I finally snapped some good pics too, here you go without further ado