Should a 10xl on 5s run cooler that a 9xl on 4s?

[TexasSP]

That's pretty little hacker knock off lutach! :D

[lutach]

Originally Posted by TexasSP

That's pretty little hacker knock off lutach! :D

It looks good . Pretty much Feigao, KD and a couple other had to copy from somebody . I just hope they are good.

[tom255]

I have realy bad experince with KD36-74-9XL motor http://www.hobbycity.com/hobbycity/s...idProduct=6678

It supposed to run cooler that my Feigao 7XL and ran Hotter actualy then geared even lower speed than 7XL it cogged and Mamba Max heated up pretty fast too and on the end of run inner magnet came loose from shaft. Total runtime about 10min. Its waist of money

[lutach]

Originally Posted by tom255

I have realy bad experince with KD36-74-9XL motor http://www.hobbycity.com/hobbycity/s...idProduct=6678

It supposed to run cooler that my Feigao 7XL and ran Hotter actualy then geared even lower speed than 7XL it cogged and Mamba Max heated up pretty fast too and on the end of run inner magnet came loose from shaft. Total runtime about 10min. Its waist of money

I will be trying a KD36-74-9XL in a few days. I do have the KD36-50-6S and it's been through hell. I tried it in my truggy one time and it pushed it. The only problem was the front end was loose. I'll report back to see if they do heat up like the one you have.