Quote:
Originally Posted by lincpimp
So nobody here has ever sent a plett back for repairs...?
|
I have.
Ran my Big maxx twice on 4s with MM, about 15 min total (about 130 max temp), and 3 times on 6s with MGM about another 15 min total (barely even warm), and the rotor demagnetized. I figured they would repair or replace it under warranty, since it was a high end motor and FD replaced a nemesis blue 8XL after demagetizing in less than 30 min no question asked. They blamed the problem on the MGM controller, there was no way it could have been defective ("each motor 100% checked before leaving factory"), and would not cover it under warranty. It would have cost nearly $200 to have it repaired (rotor, labor, return shipping), but after some begging and pleeding the guy checked with Mr. Plettenberg and I managed to get the price cut in half.
Quote:
Originally Posted by What's_nitro?
Instead of sending it back, why don't you just order a new rotor with the 5mm shaft from them and install it yourself? Then you only need to pay for the parts, and wait for shipping one-way.
|
I would just order up the rotor, it will be expensive enough.
Threaded Mode
